Saturday, 4 May 2013

How To: Change Your Ip In Less Then 1 Minute.

1. Click on "Start" in the bottom left hand corner of screen


2. Click on "Run"

3. Type in "command" and hit ok You should now be at an MSDOS prompt screen.

4. Type "ipconfig /release" just like that, and hit "enter"

5. Type "exit" and leave the prompt

6. Right-click on "Network Places" or "My Network Places" on your desktop.

7. Click on "properties" You should now be on a screen with something titled "Local Area Connection", or something close to that, and, if you have a network hooked up, all of your other networks.

8. Right click on "Local Area Connection" and click "properties"

9. Double-click on the "Internet Protocol (TCP/IP)" from the list under the "General" tab

10. Click on "Use the following IP address" under the "General" tab

11. Create an IP address (It doesn't matter what it is. I just type 1 and 2 until i fill the area up).

12. Press "Tab" and it should automatically fill in the "Subnet Mask" section with default numbers.

13. Hit the "Ok" button here

14. Hit the "Ok" button again
You should now be back to the
"Local Area Connection" screen.

15. Right-click back on "Local Area
Connection" and go to properties
again.

16. Go back to the "TCP/IP" settings

17. This time, select "Obtain an IP address automatically"

18. Hit "Ok"

19. Hit "Ok" again

20. You now have a new IP
address With a little practice, you can easily get this process down to 15 seconds.

3 comments: